General
ID #1065
How do I setup a static IP address with Linksys/Sipura PAP2/PAP2T/SPA from IVR?
To turn DHCP on or off, and setup a static IP address from IVR on Linksys PAP2, PAP2T, or SPA devices, please use the following table for reference:
Share this page:
| Action | Menu Choice | User Input | Notes | |||||||||||||
| Enter IVR Menu | * * * * | None | None. Ignore SIT or other tones until you hear, “Linksys configuration menu. Please enter option followed by the pound key or hang-up to exit.” | |||||||||||||
| Check DHCP | 100# | None | IVR will announce if DHCP in enabled or disabled. | |||||||||||||
| Enable/Disable DHCP | 101# | Enter 1 to enable Enter 0 to disable |
||||||||||||||
| Check IP Address | 110# | None | IVR will announce current IP Address of PAP2. | |||||||||||||
| Set Static IP Address | 111# | Enter IP address using numbers on the telephone key pad. Use the *(star) key when entering a decimal point. | DHCP must be “Disabled” otherwise you will hear, “Invalid Option,” if you try to set this value. | |||||||||||||
| Check Network Mask | 120# | None | IVR will announce the current network mask of PAP2 | |||||||||||||
| Set Network Mask | 121# | Enter value using numbers on the telephone key pad. Use the * (star) key when entering a decimal point. | DHCP must be “Disabled” otherwise you will hear, “Invalid Option,” if you try to set this value. | |||||||||||||
| Check Static Gateway IP Address | 130# | None | IVR will announce the current gateway IP address of PAP2. | |||||||||||||
| Set Static Gateway IP Address | 131# | Enter IP address using numbers on the telephone key pad. Use the *(star) key when entering a decimal point. | DHCP must be “Disabled” otherwise you will hear, “Invalid Option,” if you try to set this value. | |||||||||||||
Tags: linksys, sipura, spa, pap2, pap2t
Related entries:
Last update: 2009-04-23 17:41
Author: Nitzan Kon
Revision: 1.0
You cannot comment on this entry